Sec. 82.008. COMPLIANCE WITH GOVERNMENT STANDARDS. (a) In a products liability action brought against a product manufacturer or seller, there is a rebuttable presumption that the product manufacturer or seller is not liable for any injury to a claimant caused by some aspect of the formulation, labeling, or design of a product if the product manufacturer or seller establishes that the product's formula, labeling, or design complied with mandatory safety standards or regulations adopted and promulgated by the federal government, or an agency of the federal government, that were applicable to the product at the time of manufacture and that governed the product risk that allegedly caused harm.

(b) The claimant may rebut the presumption in Subsection (a) by establishing that:

(1) the mandatory federal safety standards or regulations applicable to the product were inadequate to protect the public from unreasonable risks of injury or damage; or

(2) the manufacturer, before or after marketing the product, withheld or misrepresented information or material relevant to the federal government's or agency's determination of adequacy of the safety standards or regulations at issue in the action.

(c) In a products liability action brought against a product manufacturer or seller, there is a rebuttable presumption that the product manufacturer or seller is not liable for any injury to a claimant allegedly caused by some aspect of the formulation, labeling, or design of a product if the product manufacturer or seller establishes that the product was subject to pre-market licensing or approval by the federal government, or an agency of the federal government, that the manufacturer complied with all of the government's or agency's procedures and requirements with respect to pre-market licensing or approval, and that after full consideration of the product's risks and benefits the product was approved or licensed for sale by the government or agency. The claimant may rebut this presumption by establishing that:

(1) the standards or procedures used in the particular pre-market approval or licensing process were inadequate to protect the public from unreasonable risks of injury or damage; or

(2) the manufacturer, before or after pre-market approval or licensing of the product, withheld from or misrepresented to the government or agency information that was material and relevant to the performance of the product and was causally related to the claimant's injury.

(d) This section does not extend to manufacturing flaws or defects even though the product manufacturer has complied with all quality control and manufacturing practices mandated by the federal government or an agency of the federal government.

(e) This section does not extend to products covered by Section 82.007.

Added by Acts 2003, 78th Leg., ch. 204, Sec. 5.02, eff. Sept. 1, 2003.