81A-12. Fee schedule.

The following fees apply to all weights that are tested and certified to meet tolerances less stringent than the American Society for Testing and Materials (ASTM) Standard E617 Class 4. This includes the National Institutes of Standards and Technology (NIST) Class F tolerance. If the weight error exceeds three-fourths of the applicable tolerance, adjustment may be required at an additional fee equal to the normal fee. No extra fee shall be charged for the normal adjustment of a weight cart. Even if weights are rejected or condemned, fees shall be assessed for the test performed.

Even if weights are rejected or condemned, fees shall be assessed for the test performed.

(b) The following fees apply to all weights that are tested and certified to meet ASTM Standard E617 Class 4 or the International Organization of Legal Metrology (IOLM) R111 Class F2 tolerances. If the weight error exceeds three-fourths of the applicable tolerance, adjustment may be required at an additional fee equal to the normal fee. Even if weights are rejected or condemned, fees shall be assessed for the test performed.

(c) The following fees apply to all weights that are calibrated. Calibration means determining actual mass and conventional mass values with an assigned uncertainty specific to the test. If necessary and considered feasible by the metrologist, adjustments to ASTM Class 1, 2, or 3 tolerances or IOLM Class E2, F1, or F2 tolerances may be made for an additional fee of two times the normal fee. Adjustments to weights of this group shall require a minimum of 10 days for weights to return to environmental equilibrium before a final calibration value can be assigned. Even if weights are rejected or condemned, fees shall be assessed for the test performed.

(d) The following fees apply to all weights that are calibrated using NIST weighing designs. These weights are tested in groups (typically either a 1, 2, 3, 5 series or a 1, 2, 2, 5 series) and are subject to the minimum per series fee shown. The best uncertainty possible from the North Carolina Standards Laboratory shall be assigned to the mass values of the weights. If necessary and considered feasible by the metrologist, adjustments to ASTM Class 0, 1, 2, or 3 tolerances or IOLM Class E1, E2, F1, or F2 tolerances may be made for an additional fee of two times the normal fee. Adjustments to weights of this group shall require a minimum of 10 days for weights to return to environmental equilibrium before a final calibration value can be assigned.

(e) The following fees apply to volumetric standard calibration.

(f) The following fees apply to tape measures and rigid rules.

(g) The following fees apply to liquid-in-glass and electronic thermometers.

(h) Any special tests or weight cleaning shall be billed at the rate of seventy dollars ($70.00) per hour prorated to the nearest tenth of an hour, with a minimum charge of thirty-five dollars ($35.00).

(i) A minimum charge of twenty-five dollars ($25.00) per invoice shall apply.

(j) If travel is required in connection with the performance of any of these services, the Department shall be reimbursed at the rates provided in G.S. 138-6.

(k) The Department may refuse to accept for testing any weight or measure the Department deems unsuited for its intended use.

(l) The fee for tests performed on weights or measures that will be used primarily outside of the State of North Carolina shall be twice the amounts set forth in this section.