(a) As used in this part, “firing requirement for handguns” means a test in which the manufacturer provides three handguns of the make and model for which certification is sought to an independent testing laboratory certified by the Attorney General pursuant to Section 32010. These handguns may not be refined or modified in any way from those that would be made available for retail sale if certification is granted. The magazines of a tested pistol shall be identical to those that would be provided with the pistol to a retail customer.
(b) The test shall be conducted as follows:
(1) The laboratory shall fire 600 rounds from each gun, stopping after each series of 50 rounds has been fired for 5 to 10 minutes to allow the weapon to cool, stopping after each series of 100 rounds has been fired to tighten any loose screws and clean the gun in accordance with the manufacturer’s instructions, and stopping as needed to refill the empty magazine or cylinder to capacity before continuing.
(2) The ammunition used shall be of the type recommended by the handgun manufacturer in the user manual, or if none is recommended, any standard ammunition of the correct caliber in new condition that is commercially available.
(c) A handgun shall pass this test if each of the three test guns meets both of the following:
(1) Fires the first 20 rounds without a malfunction that is not due to ammunition that fails to detonate.
(2) Fires the full 600 rounds with no more than six malfunctions that are not due to ammunition that fails to detonate and without any crack or breakage of an operating part of the handgun that increases the risk of injury to the user.
(d) If a pistol or revolver fails the requirements of either paragraph (1) or (2) of subdivision (c) due to ammunition that fails to detonate, the pistol or revolver shall be retested from the beginning of the “firing requirement for handguns” test. A new model of the pistol or revolver that failed due to ammunition that fails to detonate may be submitted for the test to replace the pistol or revolver that failed.
(e) As used in this section, “malfunction” means a failure to properly feed, fire, or eject a round, or failure of a pistol to accept or eject the magazine, or failure of a pistol’s slide to remain open after the magazine has been expended.
(Added by Stats. 2010, Ch. 711, Sec. 6. (SB 1080) Effective January 1, 2011. Operative January 1, 2012, by Sec. 10 of Ch. 711.)
Copyright ©2024 LegalFix. All rights reserved. LegalFix is not a law firm, is not licensed to practice law, and does not provide legal advice, services, or representation. The information on this website is an overview of the legal plans you can purchase—or that may be provided by your employer as an employee benefit or by your credit union or other membership group as a membership benefit.
LegalFix provides its members with easy access to affordable legal services through a network of independent law firms. LegalFix, its corporate entity, and its officers, directors, employees, agents, and contractors do not provide legal advice, services, or representation—directly or indirectly.
The articles and information on the site are not legal advice and should not be relied upon—they are for information purposes only. You should become a LegalFix member to get legal services from one of our network law firms.
You should not disclose confidential or potentially incriminating information to LegalFix—you should only communicate such information to your network law firm.
The benefits and legal services described in the LegalFix legal plans are not always available in all states or with all plans. See the legal plan Benefit Overview and the more comprehensive legal plan contract during checkout for coverage details in your state.
Use of this website, the purchase of legal plans, and access to the LegalFix networks of law firms are subject to the LegalFix Terms of Service and Privacy Policy.